Pharmaceutical and personal care products removal by advanced treatment technologies

Autor/a

Chtourou, Mariem

Director/a

Monclús Sales, Hèctor

Salvadó Martín, Victòria

Walha, Kaled

Tutor/a

Comas Matas, Joaquim

Fecha de defensa

2018-10-25

Páginas

174 p.



Departamento/Instituto

Universitat de Girona. Departament d'Enginyeria Química, Agrària i Tecnologia Agroalimentària

Université de Sfax

Resumen

This thesis evaluates different technologies for treating wastewater with high concentrations of PPCPs. Firstly, a state-of-art revision of advanced treatment technology for removing Triclosan (TCS) from waste water was carried out in an attempt to evaluate the most favourable technologies and discern any major limiting factors. The technological categories evaluated were: (i) adsorption, (ii) advanced oxidation processes, and (iii) membrane technology. The results found in the second chapter are based on treating three PPCP compounds in a cyclic anoxic/aerobic membrane bioreactor. In fact, the target compounds selected for this study were specifically carbamazepine, caffeine and triclosan. The ultrafiltration membrane bioreactor process was an efficient and appropriate technology for chemical oxygen demand removal, as it achieved a removal average of 97%, removal rate for caffeine reaching up to 93.7 ± 9.7 and 89.7 ± 8.3 % for triclosan. In the case of carbamazepine, removal was lower (36.2 ± 6.8%) due to its recalcitrance. Low ammonia removal efficiencies were observed in both experimental systems suggesting that nitrification was inhibited by the presence of triclosan. The deterioration of sludge characteristics induced a fouling increment which forced several chemical cleanings to be carried out. The last section is focused on cork and evaluates its potential as a sorbent material. The cork was firstly characterized to discern its structure. Then a fixed-bed column was chosen as the most suitable technology with which to evaluate the cork adsorption. Four pharmaceuticals (diclofenac, ketoprofen, naproxen and carbamazepine) and two cosmetic compounds (triclosan and methylparaben) were treated in wastewater effluent by using a fixed-bed column. Furthermore, a novel, simple, selective and low-cost method for the pre-concentration sample before chromatography was performed in real wastewater effluent. This methodology is based on a silicone rod micro extraction combined with HPLC-DAD to simultaneous determine the concentration levels of six compounds. The adsorption capacities of cork followed this order: TCS >CBZ and MPB> KET and NAP > DCF. This behaviour could be explained by the fact that the removal of PPCPs by cork is based on hydrophobicity and the charge of the PPCP molecules. Generally, the cork showed a much higher capacity for TCS sorption, minimizing the concentrations of triclosan and avoiding the inhibition effect into biological systems, as well as minimizing fouling in MBRs


Aquesta tesi ha avualuat diferents tractament per l'eliminació d'influent amb alta concentració de fàrmacs i productes cosmètics. Primerament, una estat de l’art sobre els diferents tractaments per eliminar triclosan ha permès establir quines tipologies de tractament podrien ser els més rendibles tant a nivell operacional com de costos. Els tractaments avaluats han estat a) adsorció, b) processos d’oxidació avançada, i c) tractament per filtració amb membrana. La tecnologia de membrana va ser una de les tecnologies escollides per analitzar la capacitat per eliminar els productes farmacèutics i cosmètics, així com per poder establir les causes de l’embrutiment de les membranes. Els compostos escollit en aquest estudi van ser el triclosan, la carbamazepina i la cafeïna. Els rendiments d’eliminació van ser elevats pel triclosan i al cafeïna (>90%), mentre que la carbamazepina va ser molt inferior degut a seu poder recalcitrant (<40%). En l’experimentació també es va detectar una inhibició del procés de nitrificació, degut a la presència de triclosan. Aquesta inhibició és va confirmar en un estudi complementari on es va quantificar la pèrdua de la capacitat nitrificant en un 60%. El darrer capítol es centra en l’avaluació de l’adsorció com a tecnologia de tractament. En aquest cas s’ha utilitzat el suro com a material adsorbent i s’han presentat resultats de caracterització del material i resultats de capacitat d’adsorció. Per dur a terme l’experimentació es va triar la tecnologia de llit fix per tractar quatre composts farmacèutics (diclofenac, fetoprofen, naproxen i carbamazepina) i dos productes cosmètics (triclosan i metilparaben). La metodologia d’anàlisi va ser la micro-extracció en tub de silicona amb HPLC-DAD. Els resultats obtinguts van demostrar que el triclosan era el compost amb major capacitat de ser eliminat i el diclofenac el que presentava menors rendiments. TCS> CBZ i MPB> KET i NAP> DCF

Palabras clave

Pharmaceuticals; Fàrmacs; Fármacos; Cosmetics; Cosmètics; Cosméticos; Wastewater treatment; Tractament d'aigües residuals; Tratamiento de aguas residuales; Bioreactor; Membrane technology; Tecnologia de membrana; Tecnología de membrana; Fouling; Incrustació; Incrustación

Materias

628 - Ingeniería sanitaria. Agua. Saneamiento. Ingeniería de la iluminación

Nota

Cotutela Universitat de Girona i Université de Sfax

Documentos

tmc_20181025.pdf

3.114Mb

 

Derechos

L'accés als continguts d'aquesta tesi queda condicionat a l'acceptació de les condicions d'ús establertes per la següent llicència Creative Commons: http://creativecommons.org/licenses/by-nc/4.0/
L'accés als continguts d'aquesta tesi queda condicionat a l'acceptació de les condicions d'ús establertes per la següent llicència Creative Commons: http://creativecommons.org/licenses/by-nc/4.0/

Este ítem aparece en la(s) siguiente(s) colección(ones)